(For Jadens label printer, the Feeder Button is the single button on the top side of the printer.)
- When the printer is not running, press the feeder button once and release it, Jadens Printer will feed a blank page out.
- For each time you change the label in different sizes, please press the feeder button for about 5 seconds until you hear one beep to run the Intelligent Label Study process. Jadens Printer will feed two pieces of blank page out.
- Press and hold the feeder button for about 5 seconds until you hear two beeps. The printer will print a test page. If the test print looks good, it indicates that the printer head is working properly.
- Press and hold on the top circular button, first you will hear one beep noise, two beep noises, then three beep noises, finally consecutive five beep noises. And then release your finger, the printer will restore the factory settings.(It is not necessary to do this if the print works normally.)